LSL Risers-kit, TRIUMPH, 25 mm, Ø1 tum, svart

LSL Clamping blocks (identifier D25T) for inch handlebars
Increase the handlebar position by 25 mm

Material: aluminum
Material treatment: anodized
Fixing: between the original clamping
Adjustment: + 25 mm
Dimensions: 1 inch clamping

Our model-specific clamping blocks are mounted on the original mounting points.
For models with standard rubber mounting, this is retained. Depending on the model, the handlebar position changes from -50mm to +30mm, the value for your motorcycle is given under offset.

ACHTUNG IMPORTANT NOTE: Please check before the conversion, whether the vehicle intended for the conversion is listed in the ABE attached here with!
For each vehicle there are different requirements and conditions that allow the conversion of the clamping blocks.
The model assignments of the LSL clamping blocks listed in the ABE are tested for use with the series handlebar of the vehicle.
The additional use of an LSL accessory handlebar is possible, but may require additional modifications to the vehicle (longer lines or cables) due to a deviating shape of the handlebar.
Also the increase of the original handlebar can lead to additional changes to the vehicle.
Check whether the following conditions apply to your vehicle (-see ABE):
- Use permissible when using a compensating pad for the triple clamp
- with 20 mm longer brake line use permissible
- with 30 mm longer brake line use permissible
- with LSL instrument holder use permissible

If not observed, the operating permit for the vehicle expires!

Following items fit this product: inch handlebars